Halter hitch

Halter hitch, Hitching tie
Use: The halter hitch, sometimes called a hitching tie is used to tie the lead rope, which is attached to a horse’s halter (or to a boat), to a post or hitching rail. The benefit of the halter hitch is that it can be released by pulling on one end of the rope. Even if there is tension on the horse-side of the rope it can still be release with ease. How to tie: * Pass the working end of the rope over the standing part. Pass the working end of the rope over the standing part. * Pass the working end behind the loop. Pass the working end behind the loop. * Create a bight in the working end of the rope. The bight is then passed in front of the main loop and into the second loop. Create a bight in the working end of the rope. The bight is then passed in front of the main loop and into the second loop. * Tighten the hitch by pulling on the standing end and the bight. The hitch can be finished by passing the working end through the bight. Tighten the hitch by pulling on the standing end and the bight. The hitch can be finished by passing the working end through the bight.

Halter hitch, Hitching tie

Use: The halter hitch, sometimes called a hitching tie is used to tie the lead rope, which is attached to a horse’s halter (or to a boat), to a post or hitching rail. The benefit of the halter hitch is that it can be released by pulling on one end of the rope. Even if there is tension on the horse-side of the rope it can still be release with ease. How to tie: * Pass the working end of the rope over the standing part. Pass the working end of the rope over the standing part. * Pass the working end behind the loop. Pass the working end behind the loop. * Create a bight in the working end of the rope. The bight is then passed in front of the main loop and into the second loop. Create a bight in the working end of the rope. The bight is then passed in front of the main loop and into the second loop. * Tighten the hitch by pulling on the standing end and the bight. The hitch can be finished by passing the working end through the bight. Tighten the hitch by pulling on the standing end and the bight. The hitch can be finished by passing the working end through the bight.

Adapted from AY Honors/Knot/Halter hitch on the Pathfinder Wiki, licensed under CC BY-SA 3.0. See the original page's history for its authors.
Found a mistake? Report it.

This is an unofficial community site. It is not affiliated with or endorsed by the General Conference of Seventh-day Adventists, the North American Division, or the official Pathfinder Wiki. Content is adapted from the Pathfinder Wiki under CC BY-SA 3.0.