Skip to content

Masonry

Requirements

1. Name at least six materials commonly used by masons in the erection of walls or buildings.

2. Demonstrate ability to use properly the following:

  • a. Plumb line
  • b. Line stretcher (chicken legs)
  • c. Level
  • d. Trowel
  • e. S-tool
  • f. Mason’s hammer

3. Demonstrate a knowledge of building cement characteristics (know how to prevent sweating, cracking, shrinking, crumbling, and loss of strength).

4. Make usable mortar and state proper proportions of ingredients (lime, sand, etc.).

5. Lay a straight stone, brick, or block masonry wall at least four feet (1.2 meters) high and ten feet (3.0 meters) long, including an inside or outside corner (surface must be struck and broomed).

6. Pour a level footing, using hand mixed cement and proper reinforcement.

7. Make the forms and lay a piece of concrete walk or floor, using commercially mixed cement. Finish it and rule it.

8. Write a paragraph describing the behavior of cement; that is, its reaction to water, its adhesive qualities, how long it takes to set, etc.

Answer key & resources

Master awards

This honor counts toward:

Investiture Achievement

This honor is required, suggested or listed as an option in:

Patch history

Earlier designs of this patch. See all outdated insignia.

Old Masonry patchOld Masonry patch

Masonry

Changed in an unknown year

The Masonry honor originally had a small black shovel with a brick background. Later, Vocational category was completely retired and labeled as antique. During this time, the patches were produced with a gray background. This is the example seen here with Masonry. The Vocational category was brought back after a large outcry and the designs are now back to a red background. The shovel, however, was kept gray.

Found a mistake? Report it.